Conduit Help?

I’m trying to make a system with my 4004, and like my Faraday 401140 system, I want to have conduit running on the board. My plan is to use Wiremold on this project since I have some just lying around. Unfortunately, I ran into a problem, which you can see in the pictures below.

http://firealarms.exofire.net/site/other/uploader/uploads/100_2561.JPG

http://firealarms.exofire.net/site/other/uploader/uploads/100_2562.JPG

The conduit holes are pretty far offset from the wall, and the Wiremold adapter doesn’t even come close to the wall. So does anybody know of something that I can do to still be able to have the Wiremold exposed on the front of the board? and Is there some sort of adapter that I can buy at a store like Home Depot or Lowe’s that will fix this problem?

I’ve used the same wiremold adapters and just drilled new holes that were closer to the wall.

the sdx has the right idea. you can also bend the wiremold unless you are using the plastic stuff

Try one of these…

http://www.hardwarestore.com/media/product/232363_front200.jpg

1/2 offeset connector. Buy one and see if that gets you on the wall. If it does you have options to enter boxes.