Hi everyone, I recently just got the last few cards for my 2001 repack installed and am now ready to wire the panel up on a small demonstration system. I have no idea how to wire up the bell and initiating circuits, however, and the few available schematics are pretty confusing. I do understand that the eight terminals under each card correspond to the card, but I’m not too sure which of the eight terminals to use. The way my 2001 is set up is that I have the main control card on the left, followed by a dual signal card, a march time card, another dual signal card, three dual zone cards and a blank module on the far right. The panel also has the AC signal module which is where my signals will need to be wired to. I just need to know which terminals (1-24) to connect the bell and initiating circuits to. If anyone knows I’d appreciate it.
PM sent.