One of our buildings has a gamewell 7100-1 fire control panel in it with ASD-PL2F photo heads installed. One of the sensors went bad so ordered a replacement the ASD-PL2F have been discontinued but was told the ASD-PL3 was a direct replacement. New head cam in and set the swiches to the same as old head and installed reset panel and said normal condition for about 45seconds and then showed falt on that head. Not sure if i need to do something in the programing for the replacemet head i wouldent think so. Any help would be grealy appreciated
1 Like
Hi
You will need ASD-PL3-IV detector model to work on CLIP mode