Simplex system Nac Compatibility?

Hello,

Looking to takeover a conventional Simplex system with four nac circuits with 4906-9127 hom strobes and 4906-9101 strobes. What conventional panel can support these devices ?

Thanks,

Jason

These devices use Simplex’s SmartSync protocol, so no panel outside of Simplex units will natively support these devices with any out-of-the-box settings.

However, you are able to use an external sync module or NAC panel to run these devices:

  • SmartSync Sync Control Module (PID: 4905-9938)
  • IDNet NAC Power Extender (PID: 4009-9201)
    – These can be wired up to activate conventionally, just follow the service/installation instructions, which can be found here.

Thanks can we use a new conventional panel and trigger the Simplex 4009-9201Nac Extender Nac power supply with the NAC output on the new facp ? So we would only replace the Simplex facp.

Yes. The 4009 is designed with what is called “hardwired operation” for this exact use-case! I have attached a wiring diagram provided by Simplex below. You may find that and other examples on page 20 of the installation instructions I provided above.